Black & Decker GLC1423L Original Instructions Manual

Black & Decker GLC1423L Original Instructions Manual

Hide thumbs Also See for GLC1423L:



Table of Contents

Summary of Contents for Black & Decker GLC1423L

  • Page 1 GLC1423L GLC1823L GLC1825L
  • Page 5: Intended Use

    ENGLISH (Original instructions) Intended use Safety of others This appliance is not intended for use by persons Your BLACK+DECKER trimmer has been designed for (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, spaces. This appliance is intended for consumer use only. unless they have been given supervision or instruction Safety instructions concerning use of the appliance by a person responsible...
  • Page 6: Additional Safety Instructions For Batteries And Chargers

    ENGLISH (Original instructions) Additional safety instructions for grass trimmers Labels on appliance Warning! Cutting elements continue to rotate after the motor The following warning symbols are found on the appliance: is switched off. Be familiar with the controls and the proper use of the appliance.
  • Page 7 ENGLISH (Original instructions) Chargers Secure the guard (6) with the screw (12). Use your BLACK+DECKER charger only to charge the Warning! Never use the tool unless the guard is properly battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage.
  • Page 8: Hints For Optimum Use

    ENGLISH (Original instructions) For edging, the trimmer head should be in the position shown Warning! Let the tool work at its own pace. Do not overload. Disconnect the tool from the supply. Loosen the adjustment collar (6) by turning it clockwise. Whilst holding the handle (2), rotate the head (8) anti-clockwise.
  • Page 9: Maintenance

    ENGLISH (Original instructions) Automatic line feed does not work Remove the empty spool (23) from the housing. Remove any dirt and grass from the spool cover and Keep the tabs depressed and remove the spool cover housing. from the housing. Take the new spool and push it onto the boss in the Pull the cutting line until it protrudes 11 cm from the housing.
  • Page 10: Technical Data

    ENGLISH (Original instructions) Technical data needs replacement, or if it is of no further use to you, do not dispose of it with household waste. Make this product GLC1423L GLC1825L GLC1823L available for separate collection. 14.4 Input Voltage Separate collection of used products and...
  • Page 12 Australia & New Zealand Stanley Black & Decker Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 90623375 04/2015...

This manual is also suitable for:


Table of Contents