Suzuki LJ80 Owner's Manual page 53

GEARSHIFT LEVERS
LEVIERS DE SELECTION DES
VITESSES
PALANCAS DE CAMBIOS
VERSNELLINGSHENDELS
Transmission shift lever
This is the lever for controlling gear
changes and to select particular gears
direct from the neutral position, operate
as follows:
* Low (1): Move gently to the left and
then forward.
* Second (2): Move gently to the left
and then backward.
* Third (3): Move the
from the position where it is standing
naturally.
* Top (4): Move the
from the position where it is standing
naturally.
* Reverse (R): With the lever pressed
down from the position where it is
standing naturally, move it to the
right and backward.
Transfer shift lever
* H2: 2-wheel drive high range (rear
wheels drive). This position should
be used for normal driving on dry,
hard-surfaced roads.
* H4: 4-wheel drive high range (high
speed four wheels drive). This position
provides greater traction than 2-wheel
drive. Use this for driving on slippery
roads (wet, icy, snow-covered, or
muddy roads etc.) or off-road.
* N: Neutral. Engine power is not trans-
fered to wheels.
* L4: 4-wheel drive low range (low
speed four wheels drive). Use this for
climbing or descending steep hills, or
off-road driving.
Shift the transfer lever to a desired po-
sition after depressing the clutch pedal.
If you have trouble with shifting, put the
transmission in gear and release the clutch
pedal slightly while pushing the transfer
lever.
lever forward
CAUTION:
(1) Bring the vehicle to a complete
stop before shifting the transfer
lever backward
lever between 4WD high range
(H4) and 4WD low range (L4).
(2) It is permissible to shift the lever
between 2WD (H2) and 4WD high
range (H4) while driving, and the
steering must be in the straight
ahead position during the shifting
operation.
49