Compressor Assembly; Setting Up; Pipe Connections; Functional Test Of The Electronic Trigger Unit Mp - GEA InTouch HAX12P/60-4 Assembly Instructions Manual

4| Compressor assembly

?

4.1 Setting up

Fig. 6
3
D
Fig. 7
GB
F
E
Fig. 8
Fig. 9

4.2 Pipe connections

ung
Fig. 10: graduated
Zeichn.-Nr. Teile-Nr.
x.xxxx-xxxxx.x
internal diameter
10
Benennung:
400 Wasserwaage
1000
für Indesign
±0.8
INFO! New compressors are factory-filled with inert gas (3 bar nitrogen).
Leave this service charge in the compressor for as long as possible
and prevent the ingress of air.
Check the compressor for transport damage before starting any
work.
Use transport eyelet.
Do not lift manually!
Use lifting gear!
Provide adequate clearance for maintenance work.
2
Ensure adequate compressor ventilation.
Do not use in a corrosive, dusty, damp atmosphere or a
combustible environment.
Setup on an even surface or frame with sufficient load-
bearing capacity.
Single compressor preferably on vibration damper.
Duplex and parallel circuits always rigid.
ATTENTION! Do not solder as long as the compressor is under pressure.
Superheating can damage the valve. Remove the pipe supports
therefore from the valve for soldering and accordingly cool
the valve body during and after soldering.
Only solder using inert gas to inhibit oxidation products (scale).
The pipe connections have graduated inside diameters so that pipes with
standart millimetre and inch dimansions can be used.
The connection diameters of the shut-off valves are rated for maximum
compressor output. The actual required pipe cross section must be
matched to the output. The same applies for non-return valves.
Zone Änderungs-Nr.
Blatt: Maßstab: Ausgangsteil, bzw. Rohteil:
-
1/x 1:1
Werkstoff: -
1
F
E
D
C
Datum Bearb. Gepr.
B
Lieferantenzeichnung
Alternativbezug:
Baumustergeprüft
Entwicklungsstand