Compressor Assembly; Storage And Transport - GEA Bock EX-HG88e Series Assembly Instructions Manual

4 | Compressor assembly

INFO

4.1 Storage and transport

D
GB
Fig. 4
F
?
E
I
Fig. 5
16
• New compressors are factory-filled with inert gas. Leave this
service charge in the compressor for as long as possible
and prevent the ingress of air.
• Check the compressor for transport damage before starting any
work.
• Before starting work, obtain written work release.
• Observe national regulations when setting up explosion-protected
systems (within the EU: ATEX Directive 1999/92/EG, EN 60079-14,
EN 60079-17 a.o.).
• Use only tools permitted for explosion-protected systems (within
the EU, in accordance with EN 1127-1).
• Observe work safety rules (TRGS 727, e.g. protective shoes,
clothing etc.)!
Storage at (−30 °C) - (+70 °C), maximum permissible relative
humidity 10 % - 95 %, no condensation
Do not store in a corrosive, dusty, vaporous atmosphere or in a
combustible environment.
Use transport eyelet.
Do not lift manually!
Use lifting gear!