Date And Time - Mitsubishi Electric Apricot LS340 Owner's Handbook Manual

IDE Translation Mode
Select Extended CHS (cylinder, head, sector) to enable the scheme
that allows the BIOS to access hard disk drives of greater than 504
Mbytes capacity. You might need to select Standard CHS if your
operating system does not support Extended CHS for large drives.
Hard disk drives
Hard disk size and type is auto-detected when the computer is
turned on, but two other parameters can be manually set for each
drive.
Parameter
Transfer Mode
Determination
Logical Block Address
(LBA) Mode
CD-ROM drive
The BIOS will detect the presence of a CD-ROM drive when the
computer is turned on. It will be shown as CD-ROM Drive 2
(allowing for Hard Disk Drives 0 and 1).

Date and Time

Use this to adjust the motherboard's Real Time Clock (RTC). This
clock is maintained by a battery while the computer is turned off.
Time
The time is in 24-hour format. Use the
ARROW
new values use the number keys, or the
to increase or decrease the number.
U s i n g t h e B I O S S e t u p U t i l i t y
Settings
You
Automatic. If you select Manual then you
will be required to specify the Polled I/O
transfer mode of the hard disk drive.
Select Supported if your hard disk drive is
8 Gbytes or larger as LBA mode offers
significant performance benefits.
keys to move from hours to minutes to seconds. To enter
APRICOT LS/VS340 OWNER'S HANDBOOK
can either select Manual
LEFT ARROW
(+) and
PLUS
or
and
RIGHT
(–) keys
MINUS
3/7