Rps Status Led; Mode Led; 10/100/1000Base-T Autosensing Ethernet Port Led - H3C S5560X-EI Series Installation Manual

RPS status LED

The S5560X-34S-EI and S5560X-54S-EI switches support RPS power input and use an RPS status
LED to indicate the RPS operating state.
Table 35 RPS status LED description
LED mark
RPS

MODE LED

To show more information about the switch through the port status LEDs, the switch provides a
MODE LED to indicate the type of information that the port status LEDs are showing.
You can use the mode button to change the indication of the MODE LED.
Table 36 Description for the MODE LED
LED mark
MODE

10/100/1000BASE-T autosensing Ethernet port LED

The switch provides a status LED for each 10/100/1000BASE-T autosensing Ethernet port. The port
LED and the mode LED work in conjunction to indicate the operating status of the
10/100/1000BASE-T autosensing Ethernet port.
Table 37 10/100/1000BASE-T autosensing Ethernet port LED description
Mode LED status
Steady green (rate mode)
Status
Steady green
Steady yellow
Off
Status
Steady green
Steady yellow
Flashing green (1 Hz) (available only for
S5560X-30C-PWR-EI and
S5560X-54C-PWR-EI switches)
Flashing yellow
10/100/1000BASE-T
autosensing
Ethernet port LED
status
Steady green
Flashing green
Steady yellow
Description
The RPS has normal AC input and DC output.
The RPS has no or abnormal AC input.
The RPS has no or abnormal DC output.
Description
The port status LEDs indicate port rates.
The port status LEDs indicate the duplex
mode of the ports.
The port status LEDs indicate the PoE power
supply status of the ports.
The port status LEDs indicates the IRF
member ID of the switch. For example, if the
LEDs for ports 1 to 5 are steady green and
the other LEDs are off, the IRF member ID of
the switch is 5.
Description
A link is present on the port and the port is
operating at 1000 Mbps.
The port is sending or receiving data at 1000 Mbps
The port is operating at 10/100 Mbps.
76