Auto Mode; Sound Mode; Master/Slave; Fuse Replacement - Techni-Lux UltraLED Series Manual

► Auto Mode

In this mode, you can select one of 18 preset static colors or 6 color-changing/cross
fade/chasing programs to run the whole system.
1. Press Menu button until display reads "System Mode [ xxx ]", use Up/Down button to select
System Mode [Auto] and press Enter button. Display reads:
2. Use Up/Down button to select program.
3. When color-changing/cross fade/chasing programs (prog19-24) are selected, press Enter
button to access speed, effect, color and dimmer.
Speed (1-10) goes from slow to fast as below:
sp.1 sp.2
30s 20s
► Sound Activation Mode
In this mode, the system runs built-in program to the beat of music. Step color changing and
color chasing are available in Sound mode.
1. Press Menu button until display reads "System Mode [ xxx ]", use Up/Down button to select
sound program:
2. Press Enter button to reach Sensitivity and use Up/Down to adjust sensitivity level.
► Master/Slave Mode
For large venue, multiple systems can be run in sync as Master/Slave. Use DMX cables to link
the Drivers together.
1. One of DL-ULEDDRIVER12R in the daisy chain is to be set as Master and this Master must
work under Auto or Sound mode.
2. Other drivers are to be set in Slave mode.
3. Operate the Master Driver in Auto and Sound mode to run the whole system.

Fuse Replacement

Remove the damaged fuse from its holder and
replace with exact same type fuse.
sp.3 sp.4 sp.5
10s 7s 5s
Sound Prog 01: color step changing to sound
Sound Prog 02: color cross fade to sound
Sound Prog 03: color strobing to sound
Up
Sensitivity
[ 01 ]
Down
Lowest
Prog xx
[ xxx ]
sp.6 sp.7
4s 3s
Sensitivity
[ 99 ]
Highest
9
sp.8 sp.9 sp.10
2s 1s 0.5s
Fuse