East Tester ET4501 User Manual page 9

ET4501/4502/4510 台式 LCR 数字电桥操作手册
Quickly switch the frequency of fixed point.
Quickly switch the test range.
Quickly switch the test speed.
Cancel input
Quickly switch between such two interfaces as "measurement display" and "system
setting".
Press down to make the measurement condition (bias, comparator setting)
input state and press down again to exit the input state.
In the input state, press this key. The interface displays
takes effect.
Quickly switch the main parameters, in the input mode, the interface display SHIFT,
represents the number 1.
Quickly switch
input mode, when the interface displays SHIFT, it represents the number 2
Enable data retention .In input mode, when the interface displays SHIFT, it represents
the number 3.
Quickly switch secondary parameters.In input mode, when the interface displays
SHIFT, it represents the number 4.
Quickly set the value of the tolerance value (only valid on the comparator
interface).In input mode, when the interface displays SHIFT, it represents the number 4.
Quickly switch between normal display and relative display.(only valid at
comparator interface, power off part is lost).In input mode, when the interface displays SHIFT, it
represents the number 6.
Quickly switch DCR dc resistance test function.In input mode, when the interface
displays SHIFT, it represents the number 7.
Quickly save the current
杭州中创电子有限公司
the comparator Settings and measurement display interface. In
set's comparator parameters.In input mode, when the
enter the
"SHIFT" and the number key
6