Table of Contents
Advertisement
Section 2 - Installation
Follow the instructions below to install a hard drive, connect to the network and power on the ShareCenter Pro. Open the
shipping carton for the ShareCenter Pro and carefully remove and unwrap its contents. Follow the instructions below to setup
the ShareCenter Pro. If this is the first time using the ShareCenter Pro or if a new hard disk is installed, use the Easy Search utility
located on the Installation CD and follow the instructions for setting up, configuring and formatting the new drive.
To install ShareCenter Pro on your local network, refer to the steps below:
1. Put a 3.5" SATA hard drive into a drive tray and use
screws to fasten the hard drive with the tray. There are
four holes for fastening the screws. Two holes are circled
in red in the image, and the other two holes are on the
other side of the drive tray.
2. Open the faceplate to access the drive bays.
D-Link ShareCenter Pro 1200-05 User Manual
Installation
Hardware Setup
8
Advertisement
Table of Contents
