Installation; Installing The Switch Without A Rack - D-Link DXS-3610-54S Quick Installation Manual

48-port 10g sfp+, 6-port 100g qsfp28 layer 3 stackable managed switch with 2 ac power supplies and 5 fan modules

Hide thumbs Also See for DXS-3610-54S:

Table of Contents

Available languages

Installation

This section is used to guide the user through installing the Switch in an area other than a switch rack. Attach

the included rubber feet to the bottom of the Switch. Take note that there should be marked blocks on the

bottom of the Switch to indicate where to attach the rubber feet. These markings are usually found in each

corner on the bottom of the device. The rubber feet cushion the Switch, protecting the casing from scratches

and preventing it from scratching other surfaces.

Figure 6. Attaching rubber feet to the Switch

Installing the Switch in a Standard 19" Rack

This section is used to guide the user through installing the Switch into a switch rack. The Switch can be

mounted in a standard 19"(1U) rack using the rack mounting kit included in the package contents.

Fasten the frontal rack-mounting brackets to the front-sides of the Switch using the screws provided.

Figure 7. Attaching the frontal rack-mounting brackets

Figure 8. Frontal rack-mounting brackets attached

Table of Contents