Table of Contents
Advertisement
Interface Connectors
2
1
Figure 2: DAP-3711 Interface
#
Feature
Reset
Resets the device to its factory
1
Button
settings.
Uses a standard Ethernet cable
2
LAN Port
to connect to devices such as
computers and switches.
Uses a standard Ethernet cable to
connect the device to a PoE power
3
PoE Port
source such as a PoE switch or PoE
injector.
Table 2: Interface Descriptions
Hardware Installation
Powering the Access Point
To power the DAP-3711, use a standard Ethernet
cable to connect the PoE port on the DAP-3711
to a PoE power source device such as a PoE
switch or the included PoE injector.
2
3
Description
Cable Requirements
Use a CAT 5 cable with an even sheath. The
Ethernet ports on the DAP-3711 access point
cannot accept a CAT 5 cable that has an uneven
sheath; the RJ-45 connector on the cable will
not fit properly into the receptacle on the
access point.
Configuring the Access Point
To set up and manage the DAP-3711, use one
of the following methods.
Connecting Through a Computer
1.
Use an Ethernet cable to connect the
DAP-3711 to the management computer.
2.
Ensure the computer is configured with a
static IP address in the 192.168.0.2/255
subnet.
Launch a web browser. Enter 192.168.0.50
3.
in the address field of your browser.
4.
Log in to the administration user interface.
The default login information is:
Username: admin
Password: admin
DAP-3711
Figure 3: Direct Connection
Quick Installation Guide
Computer
Advertisement
Table of Contents
