Knee Lifter Lever - Janome HD9 Service Manual

q

13. Knee Lifter Lever

The presser foot rises 7 to 8 mm when it is fully raised
with the knee lifter.
z
x
• If it is lower than 7 to 8 mm, turn the adjusting screw e
7 to 8 mm
• If it is higher than 7 to 8 mm, turn the adjusting screw e
w
c
NOTE:
Lower the needle bar to the lowest position and check
if the needle cramp does not hit against the presser foot
when it is fully raised.
e
10
Remove the base and lay the machine on its back.
Loosen the nut q on the knee lifter lever w slightly
and turn the adjusting screw e to adjust the height.
clockwise.
counterclockwise.
Tighten the nut q firmly and attach the base.