e
w
q
t
w
r
q
e
r
y
14. Needle Threader
To remove:
Remove the face plate.
z
Pull the threader q out from the threader shaft w.
x
To attach:
Align the groove e of the threader with the pin r on
c
the threader shaft. Push the threader up until it snaps
in place.
To adjust:
If the threader hook q thrusts or hits against either
z
left or right edge of the needle eye w:
Loosen the setscrew e. Move the threader plate r
to adjust the lateral position of the threader hook q.
If the threader hook q thrusts or hits against either
x
top or bottom edge of the needle eye w, or misses
the needle eye w:
Loosen the setscrew t. Move the threader position
setting plate y up or down to adjust the vertical
position of the threader hook q.
11