Knee Lifter Lever - Janome 1600P-QC Service Manual

q
7.5mm
w
e
11

13. Knee Lifter Lever

The presser foot rises 7.5 mm when it is fully raised with
the knee lifter.
z
Remove the base and lay the machine on its back.
x
Loosen the nut q on the knee lifter lever
and turn the adjusting screw
• If it is lower than 7.5 mm, turn the adjusting screw
clockwise.
• If it s higher than 7.5 mm, turn the adjusting screw
counterclockwise.
c
Tighten the nut q firmly and attach the base.
NOTE:
Lower the needle bar to the lowest position and check if
the needle cramp does not hit against the presser foot when
it is fully raised.
w slightly
e
to adjust the height.
e
e