Continuity Test; Maintenance; Store Of Test Leads; Accessories - Mastech MS8216 User Manual

Pocket Digital Multimeter
2.If the lead connection is reversed, only figure'0L'will
be displayed.

4.13 Continuity test

4.13.1 Set the transform switch at the
4.13.2 Connect test leads across two points of the
circuit under testing.
4.13.3 If continuity exists（i.e., resistance less than
about 50Ω）, built-in buzzer will sound.
4.13.4 You can get reading from LCD.
NOTE:
If the input open circuit(or the circuit resistance
measured is higher than 400Ω), then the figure'0L' will
be displayed.

5. Maintenance

5.1 Replacing The Batteries
WARNING
To avoid electric shock, make sure that the test
leads have been clearly move away from the
circuit under measurement before opening the
battery cover of the meter.
WARNING
Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
5.1.1 If the sign " " appears, it means that the
batteries should be replaced.
5.1.2 Loosen the fixing screw of the battery cover and
remove it.
5.1.3 Replace the exhausted batteries with new ones.
range position.
14
Pocket Digital Multimeter
5.1.4 Put the battery cover back and fix it again to its
origin form.
Note:
Do not reverse the polarity of the batteries.
5.2 Replacing Test Leads
Replace test leads if leads become damaged or worn.
Use meet EN 61010-031 standard, rated CA T III 600V, or
better test leads.

5.3 Store of test leads

When placing the teat leads in the storing space, first
roll its wire 3 times, then put it into the store space as
illustrated.

6. Accessories

Battery: 1.5V LR44
Operating Manual
WARNING
2Pcs
1Pcs
15