Pyronix Enforcer 32WE Quick Start Manual page 4

Wireless Signal Strength Indicator (SSI)
One of the key advantages of implementing ITDC technology is to allow the installer to view the wireless
transmission signal strength on both the control panel and wireless devices in real time.
This feature is known as the wireless Signal Strength Indicator (SSI).
Each wireless device has an inbuilt wireless signal strength indicator to allow the installer to view the signal
strength on the device during the installation.
SSI On The Wireless Device
GREEN
If a LED illuminates on the device, the wireless signal is strong enough at the location of
where the device is to be installed.
RED
If a LED illuminates on the device, the wireless signal is not strong enough at the location of
where the device is to be installed.
SSI On The Control Panel
The signal strength for each device can also be viewed on the control panel itself in two ways:
Snapshot View:
This method allows the installer to view all inputs at
once on the LCD display showing 3 as Excellent
signal strength, 2 as Good signal strength, 1 as
Weak signal strength and 0 as out of range signal.
Device Missing (0)
Signal Weak (1)
Signal Good (2)
Signal Excellent (3)
Individual View:
This method allows the installer too view the signal
strength of each individual wireless device in
percentages between 0% to 100%.
If the SSI reading is less than 10% the device
should be relocated to a location with a higher
percentage of wireless transmission.
Signal Excellent (80%)