How To Remove - Britax safe-n-sound BS7300N-020133 Series Instructions For Installation & Use

HOW TO USE
H. Remove the slack from the top tether strap by
pulling adjustment strap as shown.
Ensure the strap is not so tight as to lift the seat
or deform the headrest.
I. Always roll up excess strap and place in the
pocket provided attached to the cover.
REMOVING CHILD FROM RESTRAINT
A. Press top tether strap adjuster button while pulling top
tether straps to slacken. Allow top tether straps to fall
to the sides for easy access to child.
B. Push and hold the harness adjustment button while
pulling both shoulder harness straps to fully slacken
the harness.
C. Press the red button on harness buckle, both harness
tongues will be released. Insert buckle tongues into
harness tongue holders to hold harness straps away
from the child. Move each shoulder strap to baby's side
then pick up baby.
36
Instructions for Installation & Use - Series No. BS7300N-020133
Press
Pull Adjustment
Strap to remove
H
slack
Roll up excess strap
and store in the pocket
attached to the cover
to avoid tripping when
I
moving the restraint.
Harness Tongue Holders (if fitted)
REMOVE RESTRAINT FROM VEHICLE
DISCONNECT TOP TETHER AND
SEATBELT
A. Disengage the vehicle seatbelt buckle from any
lock-off devices. Remove seatbelt from the restraint
belt paths.
B. Remove the top tether strap from pocket and fully
press top tether adjuster button (A) while pulling top
tether strap (B) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
C. Disengage the attachment clip from upper anchorage
fitting. The child restraint is now disconnected.
D. To store the stabilising bar, lift the front flap
at the end of the seat, this uncovers the
stabilising bar storage recess.
E. Press the blue button on left side (facing
seat) and gently push stabilising bar back
and then down into the recessed area.
F. Re-attach the front flap at the end of the
seat.
Instructions for Installation & Use - Series No. BS7300N-020133

HOW TO REMOVE

Fully press Adjuster Button (A)
while pulling Top tether Strap (B) to
lengthen.
A
B
B
Hook and Loop
attachment
Stabilising
bar
front
flap
D
Rotate
backwards
Then push
inwards
Button under trim
37