(1) Untwist the twisted pair shielded cables after stripping its sheath.
Also, perform protective treatment of the shield to ensure that it will not
make contact with the conductive area.
Strip off the sheath about the size as in the right figure. If the length of the
sheath peeled is too long, a short circuit may occur among neighboring
wires. If the length is too short, wires might come off.
Wire the stripped cable after twisting it to prevent it from becoming loose.
(Do not solder it.)
Cable stripping length
Use a blade type terminal as required.
INSTALLATION AND WIRING
(perform protective treatment)