INSTALLATION AND WIRING
• Information on blade terminals
Commercially available product examples (as of Jan. 2010)
Blade terminal crimping tool: CRIMPFOX 6T-F/6 (Phoenix Contact Co., Ltd.)
Insert wires to a blade terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.
Check the condition of the blade terminal after crimping. Do not use a blade terminal of which the crimping is
inappropriate, or the face is damaged.
(2) Loosen the terminal screw and insert the cable into the terminal.
• Undertightening can cause cable disconnection or malfunction. Overtightening can cause a short circuit or
malfunction due to damage to the screw or unit.
With insulation sleeve
0.22N⋅m to 0.25N⋅m
Blade Terminal Model
Without insulation sleeve
(Tip thickness: 0.4mm/tip width: 2.5mm )
Wires are not inserted
into the shell