Prem-I-Air EH1672 User Manual page 7

results, do not use the exhaust tube, but fit a permanent drainage pipe
to the drain outlet as shown on page 4.

/HEAT mode: heats if the room temperature is below the selected
temperature. Use the
temperature. The temperature can be set between 16C and 30C
(60F - 86F). When the temperature reaches desired level the
compressor will stop, and the fan will continue to run. Heating
performance reduces if the outdoor temperature falls below 7 °C. in this
mode the fan will run at

/Fan mode: circulates the air, but does not affect room temperature
or humidity. The fan speed can be altered by pushing the
fan has 3 speeds indicated by the
the unit display.

/ Energy Saving: The energy saving function on this unit runs the
fan at
2min 30s. The unit will also switch off the duct fan and compressor
when the cooling temperature reaches the set level and will not switch
on till the temperature rises above this level.
/SLEEP (Press
button is pressed the
/Lo speed and cannot be adjusted. Only works in
modes. In /COOL mode the set temperature will increase 1°C after 2 hours
and a further 1°C after another 2 hours then remain constant. In
the set temperature will decrease 1°C after 2 hours and a further 1°C after
another 2 hours then remain constant. The sleep mode will automatically be
cancelled on any change of running mode.
/TIMER: This function allows an auto ON or OFF time to be set. The LCD
display will show a flashing
the second 2 for minutes. You can use the
minute intervals. If the unit is switched on and working then setting the timer will
set the running time till the unit switches OFF. If you wish the unit to start in a
pre-determined time then first turn the unit on and select the mode and
temperature desired, and then power the unit down by touching the power
button. Now push the
set the time till you wish the unit to start in 30 min intervals. The unit will start to
count down and will start automatically with the last selected mode and
temperature as set earlier.
/SWING (Press
the icon will appear on the LCD screen and the horizontal louver will slowly
raise and lower to distribute the air evenly. Press again to cancel.
/Lo speed only and sets the fan to run for 30s on then off for
+ buttons at the same time on panel): When the sleep
icon appears in the LCD display and the fan runs at
/TIMER button and the display will show
+ buttons at the same time on panel): When selected
and buttons to select the desired room
/Lo speed
/Lo,
symbol. The first 2 digits are for hours and
and
Page 7
/Med and /Hi symbols on
/HEAT and
/HEAT mode
buttons to set the time in 30
button, the
/COOL
, now