Adding Paper To The Large Capacity Feeder (Optional) - Toshiba E-STUDIO E-Studio 3511 Operator's Manual

Adding Paper to the Large Capacity Feeder (Optional)

1
Pull out the large capacity feeder carefully
until it comes to a stop.
2
Set paper aligned in tray (A) and tray (B).
- Place the paper face up.
- Maximum number of sheets that can be set. "Acceptable Copy
Paper Types and Sizes"
- Fan the paper well, then set it for (A) to the right side, and set it
for (B) to the left side. (The paper can be set neatly if you pile up
the paper little by little alternately in the tray (A) and (B).) Be sure
that the center lever is not open. (Refer to the labels attached in
the large capacity feeder.)
- Do not add paper above the line indicated on the guide.
- Paper starts being fed from the elevator tray (A) at first, and when
it runs out, the paper on the tray (B) moves to the position (A).
- Do not use creased, folded, wrinkled or damp sheets of paper.
3
Push the drawer of the large capacity
feeder straight into the equipment until it
comes to a stop.
- Close it completely. The elevator tray automatically moves up to
the paper feeding position.
Be careful not to let your fingers be caught when closing the drawer.
This could injure you.
Page 38
( A )
( B )
12
249