Technical Description; Application - Siemens SITRANS P 7MF4013 Instruction Manual

Technical Description

NOTE
The transmitter must be warm up for about 5 minutes after switching on the power
in order to obtain stable measured values.
1.1

Application

The SITRANS P, MS series transmitter measures the pressure of non-aggressive
and aggressive gases as well as critical vapors and liquids. Measuring spans
between 0.03 and 400 bar are possible. The output signal is a load-independent
direct current of 4 to 20 mA which is linearly proportional to the input pressure.
Transmitters of "intrinsically safe" and "pressure-proof encapsulated" design can be
installed within hazardous areas (e.g. zone 1). The conformance certificates conform
to the European standard (CENELEC).
Transmitters fitted with various types of chemical seal are available for special
applications, e.g. measuring highly viscous media.
The transmitter can be parameterized locally by two pushbuttons or externally by
HART®. The table below describes the basic parameters. Other parameters are
accessible through HART® for special applications.
SITRANS P, MS series
C79000-B5674-C40-04
1
73