HIKOKI C 7SS Handling Instructions Manual page 9

5. Replacing supply cord
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer of this
agent in order to avoid a safety hazard.
6. Adjusting the base and saw blade to maintain
perpendicularity (only aluminum base type)
The angle between the base and the saw blade
has been adjusted to 90°, however should this
perpendicularity be lost for some reason, adjust
in the following manner:
(1) Turn the base face up (Fig. 7) and loosen the
wing-bolt (Fig. 3).
(2) Apply a square to the base and the saw blade
and turning the slotted set screw with a slotted-
head screwdriver, shift the position of the base
to produce the desired right angle.
7. Service parts list
CAUTION
Repair, modification and inspection of HiKOKI
Power Tools must be carried out by a HiKOKI
Authorized Service Center.
This Parts List will be helpful if presented with
the tool to the HiKOKI Authorized Service Center
when requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS
HiKOKI Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
English
9