Electrical Connection - Belling Cookcenter Series Installation & User's Instructions

Natural gas/lpg

Hide thumbs

Table Of Contents

Table of Contents

WARNING – THIS APPLIANCE MUST BE EARTHED.

CONNECT TO A 230-240V A.C. SUPPLY ONLY.

Connection to the electricity supply should be made via a properly earthed, readily

accessible wall socket which is adjacent to, and not more than 1.25m away from the

appliance and capable of electrical isolation.

Should this plug not fit the socket outlet in your home it should be cut off and replaced

with a suitable plug as outlined below.

Note: The removed plug cannot be used for any other appliance and should therefore

be properly disposed of and not left where children might find it and plug it into a

supply

socket – with the obvious consequent danger.

If the fitted plug is removed

The flexible mains lead must be correctly connected as below to a three pin plug of not

less than 13 amp capacity. If a B.S. 1363 fused plug is used, it must be fitted with a 3

amp fuse which is approved to B.S. 1362.

Important: The wires in the mains lead fitted to this appliance

are coloured in

accordance with the following code:

GREEN AND YELLO W

BLUE

B R O W N

As the colours of the wires in the mains lead of this appliance may not correspond with

the coloured markings identifying the terminals in your plug, proceed as follows:– The

wire which is coloured green and yellow must be connected to the terminal in the plug

which is marked with the letter E or by the earth symbol

and yellow. The wire which is coloured blue must be connected to the terminal which is

marked with the N or coloured black. The wire which is coloured brown must be

connected to the

terminal which is marked with the letter L or coloured red. When wiring the plug,

ensure that all strands of wire are securely retained in each terminal. Do not forget to

tighten the mains lead clamp on the plug. As the appliance must be earthed, do not

use 2-pin

sockets outlets, if you are in doubt, consult a qualified electrician.

Should the mains lead ever require replacement, it is essential that this operation be

carried out by a qualified electrician and should only be replaced with a flexible cord of

the same size i.e. 0.75mm

If a moulded plug is fitted

In the event of replacing a fuse in the plug supplied a 3 amp ASTA approved fuse to

BS1362 must be fitted.

NOTE: The fuse cover must be refitted when changing the fuse. In the event of losing

the fuse cover the plug must not be used until a replacement fuse cover has been

obtained and fitted. A new fuse cover can be obtained from your local Electricity

R e t a i l e r. The colour of the correct replacement fuse cover is that of the coloured marks

or inserts in the base of the plug.