Table of Contents
Advertisement
13. Reference
Symptom
You want to return the parameter
settings to their initial values.
The edited current parameter
returns to the unedited value when
the power is turned off and the unit
is restarted.
Can't patch the unit with a CL series
digital mixer using Dante Controller.
When you execute Clear Config in
Dante Controller, operation
becomes unstable.
84 | PC412-D PC412-DI PC406-D PC406-DI Owner's Manual
Possible causes
-
The power was turned off before the
current parameter was
automatically saved.
The CL series unit's Fs setting is 48
kHz, and this unit's setting is 96
kHz.
After Clear Config is executed, the
unit will not operate correctly until it
is restarted.
Possible solution
To return to the initial settings,
execute「Returning to the factory
settings
(Initialization)」.
Before turning the power off, wait at
least three seconds after an editing
operation.
In Dante Controller or on this unit,
set the Fs to match the setting of
the CL series unit.
If you executed Clear Config, you
must restart using one of the
following methods.
- When executing Clear Config in
Dante Controller, put a check mark
in [Reboot]
- After executing Clear Config, turn
this unit's power off and then on
again
- After executing Clear Config,
execute UTILITY > REBOOT from the
screen of this unit
Advertisement
Table of Contents
