Table of Contents
Advertisement
● For the PC-DI series
This product uses Euroblock connectors (7.6 mm 8-pin) for speaker connections.
Insert the tip of a screwdriver into the square hold located on the top of the cable insertion opening. Inserting the
screwdriver and lifting the internal spring allows the cable to be inserted or removed.
The outputs of this product can be bridged in pairs of two channels.
Since there are no dedicated outputs for use in bridge mode, take care to observe the following pin assignments.
EURO A
+
-
EURO B
+
-
EURO C
+
-
EURO D
+
-
WARNING
Do not touch the pins of unused channels, or allow them to short.
High voltage is present even at unused pins.
SINGLE
BRIDGE
CH A+
CH A+
CH A-
CH A-
CH B+
-
CH B-
‐
CH C+
CH C+
CH C-
CH C-
CH D+
-
CH D-
-
PC412-D PC412-DI PC406-D PC406-DI Owner's Manual | 15
4. Connections
Advertisement
Table of Contents
