Switching The Power Between Standby/On - Yamaha PC412-D Owner's Manual

4. Connections

4.7. Switching the power between standby/on

To prevent loud noise from being emitted from the speaker when the power is turned on, power-on each unit in
the order of audio sources, mixer, and finally the amp. When turning the power off, reverse this order.
■ Standby → power on
1. Hold down the power switch for two seconds or longer.
The power turns on, and the button changes from blinking to lit (green). After a time, the HOME screen
(VOLUME) appears.
■ Power on → standby
1. Press the power switch.
The display shows a confirmation message.
2. Turn the main knob to select "YES," and then press the main knob to confirm; the power switches to
standby mode.
NOTE
• The settings at the time the power was turned off (the state when disconnected from the AC outlet)
are saved. The next time the power is turned on, the unit starts up with those settings.
NOTICE
* When this product is connected to an AC outlet, it is in standby mode, and a small amount of current is
flowing. If you will not be using this product for an extended period of time, be sure to disconnect the power
supply plug from the AC outlet.
18 | PC412-D PC412-DI PC406-D PC406-DI Owner's Manual