ABI Attachments ABI Force Z-23 Owner's Manual page 13

7. With the ABI Force started, use the bent hydraulic control
lever to raise the mid-mount attachment system clear of the
shipping crate. The bent hydraulic control lever will be the
lever furthest to the left in the hydraulic lever set. Refer to
Figure 3 for reference.
Figure 3: Bent Handle Raises Mid-mount System
8. The parking brake lever can be located on the right side of
the ABI Force connected to the dash. Push the lever forward
and down to disengage the parking brake. Refer to Figure 4
for reference.
Figure 4: Park brake location
9. Using the grip controls, slowly & simultaneously pull both
controls back slowly and together to back the ABI Force off
the shipping crate. Ensure that there are no obstacles or
people behind and that the mid-mount attachment system
fully clear. It may be beneficial to use the crating material
as a ramp to ease the unit off the skid. Watch out for nails or
screws. Use Figure 5 for reference.
Figure 5: Pull back for reverse
10. With the ABI Force clear of the shipping crate, you are
ready to begin adding attachments.
For setup assistance contact ABI's Customer Service
department. Contact information can be found in the
"Contact Us" section of this manual on page 2.
Rake Installation
1. If installing optional Edger system, install per instructions
in Edger kit. Hardware in manual canister will not be used.
2. If not installing Edger Remove hardware holding end rake
sections on Mid-mount attachment system with ½" wrench
and discard.
3. Flip Rake sections over to extend outward and install
hardware with ¾" wrenches. Hardware is provided in the
manual canister on the backrest. See Figure 6 for finished
installation.
13