ABI Attachments ABI Force Z-23 Owner's Manual page 31

4. Loosen and back out but do not remove 2 pump mount
bracket bolts as shown in Figure 49.
Figure 49: Pump mount bracket bolts
5. Pull on pump assembly to slide it towards right tire of the
machine. Exposing the drive shaft of the pump.
See Figure 50.
Figure 50: Pump drive shaft
6. Apply Molykote G-n assembly paste to a brush or craft
stick and spread on pump spline shaft.
7. Reassemble in reverse order. Apply thread locker to
pump mount bolts and torque to 35 ft lbs.
Off Season Storage
•
Use a safe dry building with proper ventilation free from
pests.
•
Check/refill both engine and hydraulic oil.
•
Wash and Clean Unit.
•
Fill fuel tank completely full using fuel stabilizer treated
gasoline.
•
Check tire pressure
Note: If optional Tweel ® tires sit loaded for long periods
of time they will develop a flat spot that rolls out once
normal use begins again.
• Remove battery or place on trickle charger to maintain
battery health.
• Cover Unit (optional)
•
Remove ALL Laser control parts and store in provided
case.
31