ABI Attachments ABI Force Z-23 Owner's Manual page 10

•
Stop the engine and disengage drive to attachment:
- Before refueling;
- Before checking, cleaning or working on the machine;
- After striking a foreign object or if an abnormal vibration
occurs. Inspect the machine for damage and make
repairs before restarting and operating the equipment.
• Turn the fuel off at the conclusion of operation. Reduce the
throttle setting during engine run-out and, if the engine is
provided with a shut-off valve.
•
Look behind and down before backing up to be sure of a
clear path.
• Slow down and use caution when making turns and
crossing roads and sidewalks.
• Do not operate the machine under the influence of alcohol
or drugs.
• Use care when loading or unloading the machine into a
trailer or truck.
• Use care when approaching blind corners, shrubs, trees, or
other objects that may obscure vision.
Maintenance & Storage
• Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
• Never store the equipment with fuel in the tank inside a
building where fumes may reach an open flame or spark.
• Allow the engine to cool before storing in any enclosure.
•
To reduce the fire hazard, keep the engine, muffler, battery
compartment and fuel storage area free of grass, leaves, or
excessive grease.
•
Keep all parts in good working condition and all hardware
and hydraulic fittings tightened. Replace all worn or
damaged parts and decals.
• If the fuel tank has to be drained, do this outdoors.
•
Be careful during adjustment of the machine to prevent
entrapment of the fingers between moving parts and fixed
parts of the machine.
• Stop engine and remove key. Wait for all movement to stop
before adjusting, cleaning or repairing. Disengage drives,
lower the implement, set parking brake.
•
Carefully release pressure from components with stored
energy. This can be done by moving hydraulic controls with
the machine off.
• Use jack stands to support components when required.
• Disconnect battery and remove spark plug wire before
making any repairs. Disconnect the negative terminal first
and the positive last. Reconnect positive first and negative
last.
• Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running. If
the engine must be running to perform a maintenance
adjustment, keep hands, feet, clothing, and any parts of the
body away from the attachments and any moving parts,
especially the screen at the side of the engine.
• Charge batteries in an open well ventilated area, away from
spark and flames. Unplug charger before connecting or
disconnecting from battery. Wear protective clothing and
use insulated tools.
• Before applying pressure to the system make sure all
hydraulic line connectors are tight and all hydraulic hoses
and lines are in good condition
• Keep your body and hands away from pin hole leaks or
nozzles that eject hydraulic fluid under high pressure. Use
paper or cardboard, not your hands, to search for leaks.
Hydraulic fluid escaping under pressure can have sufficient
force to penetrate the skin and cause serious injury. Seek
immediate medical attention if fluid is injected into skin.
• Before disconnecting or performing any work on the
hydraulic system, all pressure in the system must
be relieved by stopping the engine and lowering the
attachments to the ground.
• Use caution when using the ABI Force as a tow vehicle. Do
not exceed 750 lbs towed by the ABI Force.
•
Only use authorized attachments on the ABI Force.
Unauthorized attachments or modifications may void the
warranty.
• Check all fuel lines for tightness and wear on a regular
basis. Tighten or repair them as needed.
10