Weslo Pursuit G 2.8 User Manual page 11

FEATURES OF THE CONSOLE
Pace
Guide
Workouts
On/Reset
Button
Button
Thumb Pulse Sensor
The console offers a selection of features designed to
make your workouts more effective. While you pedal,
the console will provide continuous exercise feedback.
You can even measure your heart rate using the built-
in thumb pulse sensor.
The console also offers six pace workouts that prompt
you to vary your pedaling pace while they guide you
through effective workouts.
To use the manual mode of the console, see the
instructions at the right. To use a pace workout, see
page 13.
Before using the console, make sure that batteries are
installed (see assembly step 7 on page 8). If there is a
sheet of clear plastic on the display, remove the plastic.
All manuals and user guides at all-guides.com
Pace
Display
Button
HOW TO USE THE MANUAL MODE
1. Turn on the console.
To turn on the console, press any of the buttons or
begin pedaling. The entire display and the pace
guide will light for a moment; the console will then
be ready for use.
2. Select the manual mode.
When you turn on
the console, the
manual mode will
be selected. If
you have select-
ed a pace work-
out, reselect the
manual mode by
pressing the Pace Workouts button repeatedly
until zeros appear in the display.
3. Follow your progress with the display.
The display can show the following workout infor-
mation:
RPM—The RPM meter on the left side of the dis-
play indicates your approximate pedaling pace
(revolutions per minute).
Speed—This mode shows your pedaling speed, in
miles per hour (mph) or kilometers per hour
(km/h).
Time—This mode shows the elapsed time. Note:
When a pace workout is selected, the display will
show the time remaining in the workout instead of
the elapsed time.
Distance—This mode shows the distance you
have pedaled, in miles or kilometers.
Calories—This mode shows the approximate
number of calories you have burned.
Pulse—This mode shows your heart rate when
you use the thumb pulse sensor.
Scan—This mode shows the speed, time, dis-
tance, calories, and pulse modes, for a few sec-
onds each, in a repeating cycle. Note: The pulse
mode will appear only when you are using the
pulse sensor.
11