Black & Decker BT1000 Instruction Manual page 8

630669-00,BT1000 manual 2/15/05
• DO-Keep saw blade sharp.
• DO-Keep motor air slots free of chips and dirt.
• DO-Use blade guards at all times.
• DO-Keep hands out of path of saw blade.
• DO-Shut off power, disconnect cord from power source
and wait for saw blade to stop before servicing or
adjusting tool.
• DO-Support long work with an outboard tool rest.
• DO-Use only 10 inch diameter blades.
• DON'T-Attempt to operate on anything but designated
voltage.
• DON'T-Operate unless all clamp handles are tight.
• DON'T-Use blades larger or smaller than those which are
recommended.
• DON'T-Wedge anything against fan to hold motor shaft.
• DON'T-Force cutting action. (Stalling or partial stalling of
motor can cause major damage. Allow motor to reach full
speed before cutting.)
• DON'T-Cut ferrous metals (Those with any iron or steel
content) or any masonry.
• DON'T-Use abrasive wheels. The excessive heat and
abrasive particles generated by them will damage saw.
• DON'T-Allow anyone to stand behind saw.
• DON'T-Apply lubricants to the blade when it's running.
• DON'T-Place either hand in the blade area when the saw
is connected to the power source.
• DON'T-Use blades rated less than 5500 R.P.M.
• DON'T-Attempt to cut small pieces (hand within 6" of
blade) without clamping.
• DON'T-Operate saw without guards in place.
If you have any questions, call 1-800-54-HOW-TO
8:11 AM Page 8
copper chromium arsenate (CCA) which can be toxic. When
cutting these materials extra care should be taken to avoid
inhalation and minimize skin contact.
chemicals known to cause cancer, birth defects or other
reproductive harm. Use appropriate respiratory protection.
until complete instructions are read and understood.
For your convenience and safety, the following warning labels
are on your miter saw.
ON MOTOR HOUSING:
WARNING: FOR YOUR OWN SAFETY, READ INSTRUCTION
MANUAL BEFORE OPERATING SAW. WHEN SERVICING, USE
ONLY IDENTICAL REPLACEMENT PARTS. ALWAYS WEAR EYE
PROTECTION.
8
• DON'T-Perform any operation freehand.
• DON'T-Reach around or behind saw blade.
• DON'T-Place hands closer than 6 inches from the saw
blade.
• DON'T-Reach underneath the saw unless it is turned off
and unplugged. The saw blade is exposed on the
underside of the saw.
• DON'T-Move either hand from saw or workpiece or raise
arm until blade has stopped.
• DON'T-Use without Kerf Plate or when kerf slot is wider
than 3/8"
• DON'T- Carry saw by work extension or other accessory.
CAUTION: Some wood contains preservatives such as
CAUTION: Use of this tool can generate dust containing
CAUTION: Do not connect unit to electrical power source