Federal Signal Corporation VIEWPOINT FVPK Installation Instructions

SAFETY MESSAGE TO INSTALLERS
People's lives depend on your safe installation of
our products. It is important to read, understand and
follow all instructions shipped with the products. In
addition, listed below are some other important
safety instructions and precautions you should
follow:
• To properly install mounting kit, you must
have a good understanding of emergency
vehicle procedures and systems.
• When drilling into a vehicle structure, be
sure that both sides of the surface are clear
of anything that could be damaged.
• Refer to installation instructions packed with
light assembly for proper electrical installa-
tion and precautions.
• You should frequently inspect the light
system to ensure that it is operating properly
and that it is securely attached to the vehicle.
• File these instructions in a safe place and
refer to them when maintaining and/or re-
installing the product.
Failure to follow all safety precautions and
instructions may result in property damage, serious
injury, or death to you or others.

A. UNPACKING.

After unpacking the mounting kit, carefully
check all envelopes, shipping labels, and tags before
removing or destroying them. Ensure that the parts
listed in the KIT CONTENTS LIST are contained in
the packing carton.

B. KIT CONTENTS LIST.

Qty. Description
8 Screw, 1/4" x 3/4", Type B,
Thd. Forming
16 Pad, Mounting, Rubber
2 Bracket, Permanent, Left
2 Bracket, Permanent, Right
4 Nut, Hex, 3/8-16, S.S.
4 Washer, 3/8, S.S.
8 Lockwasher, Split, 3/8, S.S.
INSTALLATION INSTRUCTIONS
FOR
MODEL FVPK PERMANENT MOUNTING KIT
VIEWPOINT™ LIGHT ASSEMBLY
Part Number
7011A158-12
8422A033
8572280
8572281
7059A063
7072A035
7074A046
ON
C. INSTALLATION OF MOUNTING BRACKET TO
LIGHT.
1. Carefully turn one of the ViewPoint halves
upside down and place it on a surface which will not
scratch the domes.
Step C.2. requires the use of the 3/8-16 nuts
and 3/8" flat washers saved during unpacking.
2. Assemble the appropriate pair of mounting
brackets on the carriage bolts (factory installed)
using nuts, flat washers, and lockwashers as shown
in figure 1. Position the brackets adjacent to the
inboard and outboard pods allowing access to the
holes used to mount the light assembly on the vehicle
roof. Secure the brackets in position.
3. Repeat steps C.1. and C.2. on the other
ViewPoint half.

D. INSTALLATION ON VEHICLE ROOF.

1. See figure 2. Position one ViewPoint half on
the vehicle roof at the desired location. The unit
should be positioned with the pods aligned facing
forward. In addition, ensure that the unit does not
interfere with operation of other apparatus.
2. Using the mounting brackets as templates,
scribe four drill position marks on the mounting
surface.
2561048B
REV. B 195
Printed in U.S.A.
NOTE
Figure 1.