Returning The Defective Cru - EMC Avamar Data Store Gen4T Customer Service Manual

Returning the defective CRU

Output similar to the following is displayed:
Physical Disk ID
Status
State
Write Caching
Media Error Count
Firmware Revision
Serial Number
Device Speed
Media Type
Slot Number
Product ID
Other Error Count
Formatted Size
Raw Size
Native Command Queueing
Link Speed
Failure Predicted
Enclosure Device ID
Device ID
Rebuild Progress
Vendor
Disk Type
SAS Address
Predictive Failure Count : 0
The State for the hard drive that you replaced should be Rebuilding.
Note
If the State of the replacement disk drive is not Rebuilding, the node has more
serious problems than just a defective hard drive. In this case, contact EMC Customer
Support.
4. Note the values for Write Caching, Rebuild Progress (a percentage), and State
(Rebuilding).
The RAID rebuild process can take hours to complete. It is finished when State is
Online, Write Caching is Disabled, and Rebuild Progress is Not Applicable.
5. Close the terminal window.
Package the defective CRU and return it to the factory. Use the box and packing from the
replacement CRU.
: 1
: Ok
Rebuilding
:
Disabled
:
: 0
: GS18
: R16E 0000R539RP2Z
: 6.0 Gb/s
: Hard Disk Device
: 1
: ST2000NXCLAR2000
: 0
: 1.816 TB
: 1.819 TB
: Enabled
: 12.0 Gb/s
: No
: 0
: 9
1%
:
: SEAGATE
: SAS
: 5000C500837E671C
Returning the defective CRU
Replacing a Hard Drive
23