Burner Assembly - Dacor Epicure EG366 Use And Care Manual

Burner Assembly
_'_'_.. Stack Burners
Crown Burner
Crown Burner
Burner Locations
Stack Burner AssemBly
1. Put the burner rings on the burner bases as shown
below. Match the correct sizes. The bottom of the
correct size burner ring fits inside the top of the
matching burner base.
2. Turn the ring until it drops into place. Twist each ring
back and forth slightly to make sure it is properly seated.
3. Put the burner caps on top of the burner rings. The ridge
around the bottom edge of the cap goes around the top
of the burner ring.
__Step idge on bottom of
Burner Cap
Step I_
Burner Ring
Ste_ Burner Base
Stack Burner Assembly
Crown Burner AssemBly
1. Put the burner head(s) in place as shown below. The
locating tab on the burner head goes in the keyed hole
as shown.
2. Put the burner ring(s) on the burner head(s) as shown
below. Match the tabs on the bottom of the ring to the
slots on the burner head. Twist each ring back and forth
slightly to make sure it is properly seated.
3. Put the burner cap(s) on top of the burner ring(s). The
ridge around the bottom edge of the cap goes around
the top of the burner ring.
Put locating
into keyed hole
Burner Base
Keyed Hole
Crown Burner Assembly