Burner And Grate Assembly - Dacor Renaissance RNTT365GB Installation Instructions Manual
Hide thumbs
Also See for Renaissance RNTT365GB:
- Use and care manual (24 pages) ,
- Planning manual (5 pages)
Table of Contents
Advertisement
Burner and Grate Assembly
WARNING
Never attempt to operate the cooktop with any of the
burner parts removed.
Sear Burner
The sear burner gives an intense, hot 16,000 BTU flame
that is more than double the BTU of the standard burners
next to it.
1. Place the sear burner ring on top of the sear burner
base.
2. Gently twist the ring back and forth to make sure it is
properly seated.
3. Place the sear burner cap on the sear burner ring.
Align it into place.
4. Set the inner sear burner cap on the center of the
sear burner ring. Align it into place.
IMPORTANT: The burner rings seat only one way. The
burners will not operate properly unless all of the burner
pieces are properly aligned and seated.
If the burner or other parts do not fit or lay flat, reverse
the direction.
Inner sear
burner cap
Sear burner
cap
Sear burner
ring
Detail: Sear burner
base
Sear Burner Assembly (1)
10
Installation Instructions
Sear burner
grate
Sear burner
base
Standard Burners
1. Gently set the standard burner rings on the standard
burner bases. Match sizes. Make sure the cutout is
aligned to allow the sensor clearance. See diagram
below.
2. Gently twist the rings back and forth to make sure
they are properly seated.
3. Place the standard burner caps on top of the burner
rings. Make sure they are aligned.
Grates
1. Gently set the sear burner grate on the left side of
the cooktop. Line up the indentations on the bottom
of the grate with the pins on top of the cooktop. The
grate only fits on one way, so if it does not lay flat, try
reversing it.
2. Gently set the standard burner grates on top of the
standard burners. The grate fingers on the front of
the grate are shorter than the fingers on the back.
Line up the indentations on the bottom of the grate
with the pins on top of the cooktop.
Standard burner grate
Standard burner
bases
Flame
Sensor
Igniter
Standard Burner Assembly (4)
Short grate finger
(toward front)
Standard
burner cap
Cutout
Standard burner
ring
Detail: Standard
burner base
Advertisement
Table of Contents
