Burner Assembly - Dacor DISTINCTIVE DCT305 Use And Care Manual

Burner Assembly
SimmerSear Burner
.
Install the SimmerSear burner ring on the
SimerSear burner base (located on the center
of the cooktop). Line up the indentations on the
bottom of the burner ring with the pins on top of
the burner base.
2. Set the outer SimmerSear burner cap on top of
the burner ring. Make sure it is centered on top.
3. Set the inner SimmerSear burner cap on the
center of the burner base. Line up the ridge
on the bottom of the cap with the pins on the
center of the burner base.
Ridge on bottom
_ Inner burner cap
_ "_ Outer burner cap
Pin on
base
SimmerSear Burner Assembly
(Center Burner)
Standard Burners
.
Install the standard burner rings on the standard
burner bases (match sizes). Put the holes on the
edge of each ring over the igniter. Center the
tabs on the bottom of each ring in the hole in
the center of each base.
.
Install all the standard burner caps. The ridge
on the bottom of each cap must surround the
top of each ring. On model DCT305, the left rear
burner cap has tabs on the bottom that fit into
the slots on the top of the burner ring.
continued...
Ridge on bottom
of burner cap
Igniter hole
Bu_l rner ring,
top view
_--Igniter
[_ CAUTION: Top of
igniter is sharp!
Burner base
Standard Burner Assembly
Tabs on bottom of
burner cap
Burner ring,
/_@/top view
Igniter hole
Igniter
[_ CAUTION: Top of
igniter is sharp!
Burner base
Left Rear Standard Burner Assembly on DCT305
5