Starting And Stopping The 7063-Cr1; Starting The 7063-Cr1 System; Stopping The 7063-Cr1 System - IBM Power Systems 7063-CR1 Service Manual

Starting and stopping the 7063-CR1

Learn how to start and stop the IBM 7063-CR1 Hardware Management Console system to perform a
service action or system upgrade.

Starting the 7063-CR1 system

You can use the power button to start the IBM 7063-CR1 Hardware Management Console systems.
About this task
Attention: For safety, airflow purposes and thermal performance, the service access cover must be
installed and fully seated before you power on the system.
You can use this procedure to power on the system; or you can use a console and the IPMI tool to power
on the system.
Procedure
1. Before you press the power button, ensure that the power supplies are connected to the system unit
and that the power cables are connected to a power source.
2. Press the power button (7) shown in Figure 66. You may have to press the switch for 0.5 to 3 seconds.
Figure 66. Power switch for 7063-CR1
What to do next
If you press the power button and the system does not start, contact your next level of support or your
service provider.

Stopping the 7063-CR1 system

Learn how to stop the IBM 7063-CR1 Hardware Management Console systems to complete another task.
69
Common procedures for servicing the 7063-CR1