Replacing A Pcie Adapter In The 7063-Cr1 System - IBM Power Systems 7063-CR1 Service Manual

Figure 23. Removing the PCIe riser screws

Replacing a PCIe adapter in the 7063-CR1 system

Learn how to replace a PCIe adapter in the IBM 7063-CR1 Hardware Management Console system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Refer to the PCIe adapter position as shown in Figure 24.
Figure 24. PCIe adapter positions
3. Complete the following steps:
a. Replace the PCIe adapter riser (UIO Network) into the system backplane.
b. Replace the two screws to secure the PCIe riser card to the chassis as shown in Figure 25 on page
26.
Removing and replacing parts in the 7063-CR1
25