Miele HG07-W Operating Instructions Manual page 85

Issue
The optical in-operation
indicator light is
flashing quickly.
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:

Fault F601
The optical in-operation
indicator light is
flashing quickly.
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
AutoDos maintenance
required
The dishwasher does
not switch off at the end
of the programme.
The wash items may not
be clean because an
insufficient amount of
detergent was
dispensed.
The
 AutoDos function is
automatically
deactivated during the
programme sequence.
Cause and remedy
There is a fault in the AutoDos.
 Switch the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see the
"Detergent" chapter, "Automatic dispensing/
AutoDos" section).
 Activate the  AutoDos function and start the
programme again.
If the fault message appears again, there is a
technical fault. You can continue to use your
dishwasher by deactivating automatic dispensing
using the  AutoDos sensor control and manually
dispensing the detergent via the detergent
compartment.
 If you wish to use automatic dispensing again,
contact your Miele dealer.
An empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. Detergent
dosage is insufficient.
The  AutoDos function was automatically
deactivated.
 Switch the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the pouring channel of the AutoDos (see
"Detergent" chapter, "Cleaning the AutoDos"
section).
 Clean the lower spray arm (see "Cleaning and
care" chapter, "Cleaning the spray arms" section).
 Select OK to confirm each message.
 Activate the  AutoDos function by confirming the
message
AutoDos available
 Start the programme again.
The programme duration will be extended by up to
2.5 hours to flush out the AutoDos detergent outlet.
Problem solving guide
using OK.
85