Filling The Salt Reservoir - Miele HG07-W Operating Instructions Manual

Filling the salt reservoir

Before filling the salt reservoir for the
first time, you must fill it with approx.
2 l of water to enable the salt to
dissolve.
Once the dishwasher has been used
once, there is always sufficient water
in the salt reservoir.
 Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.

Danger of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
opened. Saline solution that runs out
can cause corrosion in the wash
cabinet and to the dishwasher load.
The salt reservoir should therefore
only be opened in order to replenish
the salt.
 Fill the salt reservoir with approx. 2 l
of water (first use only).
Before using for the first time
 Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
 Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
 Immediately after filling the salt
reservoir and each time you remove
the salt container cap, run the
 65 °C QuickPowerWash
programme with the  Express
programme option selected without a
load in the dishwasher to dissolve
and remove any traces of salt from
the wash cabinet.
27