Cleaning The Control Panel; Cleaning The Reflector Panel; Cleaning The Appliance Front - Miele HG07-W Operating Instructions Manual

Cleaning the control panel

 The control panel should only be
wiped with a damp cloth.

Cleaning the reflector panel

The reflector panel for the optical in-
operation indicator light is situated on
the cover sheeting underneath the
worktop.
 The reflector panel should only be
cleaned with a damp cloth if
necessary.

Cleaning the appliance front


Damage due to soiling.
Soiling that is left too long might
become impossible to remove and
could cause the external surfaces to
alter or discolour.
It is therefore best to remove any
soiling immediately.
 Clean the appliance front with a clean
soft sponge and a solution of warm
water and washing-up liquid. After
cleaning, wipe the surfaces dry using
a soft cloth.
A clean, damp microfibre cloth
without detergent can also be used.
Cleaning and care
To avoid damaging the external
surfaces, do not use the following:
– Detergents containing soda,
ammonia, acids or chlorides
– Detergents containing descaling
agents
– Abrasive detergents, e.g. scouring
powder, scouring liquid, or pumice
stones
– Detergents containing solvents
– Stainless steel cleaning agents
– Dishwasher cleaner
– Oven cleaner
– Glass cleaning agents
– Hard, abrasive brushes or sponges,
e.g. pot scourers, brushes or
sponges that have been previously
used with abrasive cleaning agents
– Eraser stain remover blocks
– Sharp metal scrapers
– Wire wool
– Steam cleaners
69