Other Features - Carrier CDF2-16Q7 Owner's Manual

AS- Humidity sensor module error--Unplug the unit and plug
it back in. If error repeats, call for service.
ES- Temperature sensor error-- Unplug the unit and plug it
back in. If error repeats, call for service.
E4- Display panel communication error.-- Unplug the unit and
plug it back in. If error repeats, call for service.
P2- Bucket is full or bucket is not in right position-- Empty the
bucket and replace it in the right position.

Other features

Bucket Full Light
Glows when the bucket is ready to be emptied, or when the
bucket is removed or not replaced in the proper position.
Auto Shut Off
The dehumidifier shuts off when the bucket is full, or when
the bucket is removed or not replaced in the proper position.
For some models the fan motor will continue operating for 30
seconds.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will
cycle off and the fan will continue to run until the frost disappears.
NOTE: When Auto defrosting operation, the unit may make a
voice of refrigerant flowing, it is normal.
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restart opertation in
the first 3 minutes. This is to protect the unit. Operation will
automatically start after 3 minutes.
Smart dehumidifying mode(optional)
At smart dehumidifying mode, the unit will automatically control
room humidity in a comfortable range 45%~55% according to the
room temperature. The humidity setting function will be invalid.
Auto-Restart
If the unit breaks off unexpectedly due to the power cut, it will
restart with the previous function setting automatically when the
power resumes.
Anti-mould function
Press the Pure pad for 3 seconds to enable this function. It sets
the fan speed and hours of operation of the dehumidifier (up to
4h) in relation to the measured actual humidity. This maximises
CONTROL PADS ON THE DEHUMIDIFIER
Indicators on Display Window:
-Air purifier light
-Anti-mould light
-Low fan speed light
-Med fan speed light
-High fan speed light
-Bucket full light
-Timer ON light
-Timer OFF light
-Dehumidifying mode
light
occupant comfort while reducing the risk of mould and bacterial
growth.
To disable the function, press the Pure pad for 3 seconds or
select an operating mode with the Mode pad.
Self-clean
Press the Turbo pad for 3 seconds to enable this function. This
function initiates as soon as the unit is switched off, and runs 15
minutes under high fan speed.
Air purifier function
This function significantly reduces the dust, bacteral and allergen
content of the room, using the HEPA (High Efficiency Particulate
Air) filter supplied with the unit.
Press the Pure pad to activate the Air purifier function, all other
modes and special functions are inhibited while it is running.
Make sure you have fitted the HEPA filter as indicated in fig.A.
Fig A
Hepa filter
Air intake grill
13
-Dryer mode light
-Continuous
Dehumidifying light
-Smart Dehumidifying
light
NOTE: When the lights
are dark, press any
pad(except the power
pad) first time, lights up
the lights. Then press
pad to operate the
desired settings.