Preparing The Printer - Printronix Auto ID ODV2D-V2 Installation Instructions Manual

2. Preparing the Printer

NOTE: If the Peel/Tear door, ODV2D-V2 Interface PCBA and Data/Power ribbon cable are pre-installed, skip forward to
section 5. Installing Mounting Bracket to Printer
1. Set the printer power switch to O (Off). Switch located on rear of printer.
WARNING Always unplug the printer power cord from the printer or the power outlet before doing any
installation procedure. Failure to remove power could result in injury to you and damage the
equipment. You will be instructed when to apply power.
2. Unplug the printer power cord from the printer or the AC power source.
4