Switching On/Off - VCS VideoJet 10 Manual

Switching on/off

Mains connection Included with the VideoJet 10 is a power supply unit.
"
"
VideoJet 10
Warning!
Use only the plug-in power supply unit supplied for operation of the
VideoJet 10. Ensure that the mains supply is free from interference
such as over voltages, spikes, or brownouts by using suitable mains
conditioners where necessary.
Only connect the VideoJet 10 to the power source after all other
connections have been established.
The VideoJet 10 is not provided with a power switch. The unit is
ready for operation as soon as the unit is connected to the power.
Insert the mains socket into the connector Power.
Connect the plug-in power supply into an earthed socket.
During the start the LED Power lights up red. The device is ready
as soon as the LED Power lights up green.
If the network connection has also been established correctly, the
green LED L also lights up. A flashing yellow LED T signals the
transport of data packages over the network.
Installation
23