Chapter 2 Safety Information; Electrical Shock Hazard - VCS VideoJet 10 Manual

Safety information

Electrical shock hazard

VideoJet 10
Never attempt to connect the unit to any power network other
!
than the one for which it was intended.
Use only the mains lead supplied.
!
Do not open the housing.
!
Disconnect the power supply unit from the mains power supply
!
and from all other devices if a fault occurs.
Install the power supply unit and server only in a dry place pro-
!
tected against the elements.
If you are uncertain about the safe operation of the unit, shut it
!
down immediately and secure it to prevent any unauthorised
start-up. Safe operation is no longer possible, for example,
– if damage is visible to the unit or the cables,
– if the unit no longer operates correctly,
– if the server has been exposed to rain or moisture,
– if objects have penetrated inside the unit,
– after long storage under improper conditions or
– after heavy demands during transport.
Have the system checked by VCS in such cases.
2
11