Metra Electronics 99-3014G Installation Instructions Manual page 5

ISO DDIN radio provision
1. Secure the radio brackets to the radio
trim panel using (4) Phillips screws
supplied. (Figure A)
2. Slide the radio between the radio
brackets, then secure using screws
supplied with the radio. (Figure B)
3. Clip the factory climate controls into the
radio trim panel. (Figure C)
4. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Complete
all connections to the radio and vehicle,
then test the radio and vehicle for
proper operation.
5. Reassemble the dash in reverse order of
disassembly to complete the installation.
KIT ASSEMBLY
(Figure A) (Figure B) (Figure C)
REV. 4/23/2019 INST99-3014G
5