General Information; Target Group; Interfaces; System Prerequisites - JUMO LOGOSCREEN nt Interface Description

2.1 Target group

2.2 Interfaces

ex-factory
Extra code

2.3 System prerequisites

This operating manual is intended for user, who want to use the paperless
recorder as a Modbus slave and read out data from a Modbus master (e.g.
PLC).
The paperless recorder is equipped with several interfaces as a standard:
• Serial interface RS232 or RS485
• Serial interface RS232 (barcode scanner)
• Ethernet 10/100 MBit/s
• 2 USB host and 2 USB device interfaces
The serial and the ethernet interfaces serves for communication with a bus
system or PC. They can be used, for example, to read out the measured
values and/or instrument and process data from the paperless recorder. In
connection with the ethernet interface and a PC webbrowser, recorders can be
monitored via the internet. Two RS232 interfaces are available. Both interfaces
are to be considered as equal.
The USB interfaces are fitted on the front and the back and intended for the
operation with the setup program or the PCA communication software (PCC)
or for reading out data via the USB memory stick. Only use one USB host or
USB device interface at a time. Instruments with stainless steel fronts are not
equipped with USB interfaces on the front.
The paperless recorder is equipped with several interfaces as an option:
• PROFIBUS-DP interface
The following items are required for interface operation:
• Connection line:
for RS232
Interface cable RS232 (9/9-pin):
Interface cable RS232 (9/25-pin):
for ethernet, e.g.
RJ 45 patch cable, CAT 5 or higher (cross over)
• Setup or evaluation program, e.g.
Setup program:
PC evaluation software PCA3000:
PCA communication software PCC:
JUMO SVS3000 Visualization:
• PC or notebook

2 General information

TN 00367735
TN 00367736
TN 00468991
TN 00431882
TN 00431879
Data Sheet
700755
7