9.5
Setting the leakage test interval
9.6
Setting the HC test
9.7
Setting CO
vrai
This menu enables you to define whether
a leakage test must be performed each
time the BEA is switched on or at certain
intervals (in days).
! Observe legal requirements when
making your entry!
Select the appropriate setting with the o
and u keys and confirm with E or by
clicking Next.
If you select and confirm the option Enter
leakage test interval, proceed to enter
the appropriate interval in days using the
keyboard, e.g.: 7 days.
Confirm your entry with E or by clicking
OK.
The OK box is displayed for 1 s.
Entry is now complete.
In this menu you can specify whether or
not an HC residues test should be perfor-
med prior to each measurement.
Select the appropriate setting with the o
and u keys and confirm with E or by
clicking Next.
The OK box is displayed for 1 s.
Entry is now complete.
This is where you can enable the change of
setting for CO
. This setting work is obli-
vrai
gatory as it is a prerequisite of configurati-
on in the Set parameters menu (Sec. 4.5).
! Observe legal requirements when
making your entry!
Select the appropriate setting with the o
and u keys and confirm with E or by
clicking Next.
The OK box is displayed for 1 s.
i If you select the option CO
disabled, the CO
test in the Set
vrai
parameters menu (Sec. 4.5.4) can no
longer be enabled.
setting
vrai
67