Checking The Interface For Rtm; Checking The Interface For Amm - Bosch BEA 150 Repair Instructions

5.2

Checking the interface for RTM

5.3

Checking the interface for AMM

Drawing of shorting plug for testing the
RTM interface.
Select the Interfaces menu, then RTM.
Insert the 15-way shorting plug in the
RTM interface on the rear of the unit.
Start the interface test by double-clicking
the mouse or by pressing Enter E .
If the interface test is error-free, the
message OK appears in the results box.
If the interface test is unsuccessful, an
error message is displayed.
For example: B0246: 1300.
1300 = No shorting plug inserted or pins
2 and 3 of shorting plug not
jumpered.
If any error messages other than this one
are displayed, the control module PCB
must be replaced (Sec. 10.27).
Select the Interfaces menu and then
AMM.
Remove the 10-way Micro-Match plug
from X5 of the control module PCB.
Plug the 10-way shorting plug into X5 of
the control module PCB.
Start the interface test by double-clicking
the mouse or pressing Enter E.
If the interface test is error-free, the
message OK appears in the results box.
If the interface test is unsuccessful, an
error message is displayed.
For example: B0246:1300.
1300 = No shorting plug inserted or pins
3 and 5 of shorting plug not
jumpered.
If any error messages other than this one
are displayed, the control module PCB
must be replaced (Sec. 10.27).
1
2
8
15
3
9
1
15
33